Search results

Wish I could tell you, my pattern hasn't changed to be "correct" but everything works fine, it only takes longer then it should to unlock the motors, failsafe and return to home work fine - I would test it carefully and see what happens. I have noticed that after I swap batteries, the second...

A few months ago getting into the hobby I purchased a new Futaba 10J radio, I'm planning on using this radio for several RC aircraft, not just my quadcopter. I've realized now that I should have bought the Futaba 10CAG, as the 10J range seems to be limited to about 1km. Does anyone know if I...

I resolved my issue, by changing the Teleporter to Wide Screen mode, I preferred it the other way - but this is good too and I can see the HUD now.

Setup my OSD mini tonight with my fatshark Teleporter 3s, everything works but the left and right side icons are getting cut off, I went into the OSD software and checked the left and right indent boxes, and it doesn't seem to move the info in far enough, anyone have a suggestion? Thanks, Mike

Just ran a few tests with mine: GPS Mode throttle @0% 2:4o to unlock ATTI Mode throttle @0% 3:10 to unlock ATTI Mode throttle @50% :32 to unlock. Here's what my lights look like in GPS Mode: YGYGYG GGGG YYY (fast blinking 13 times) Y (single yellow blink 9 times) YYY (fast blinking 19 times)...

yes, that's right, I thought it seemed like a long time myself. maybe I should record the light flashes so i can decipher if it's flashing a problem. Does the throttle need to be at 50% while the naza boots up?

Great posting, thanks. Question though, my Hex takes a long time, 75 seconds approx, from power being applied to be able to unlock the motors, it goes through what I would say is all the correct flash sequences - based on your post. Is this an unusually long time?

Okay, it's in Atti mode so that explains it.

Clean profile and redoing my settings inside of the Naza assistant did the trick, motors arm now. Thanks again.Haven't mounted my props yet, but i notice the power curve seems flat from 0-50% (by tone of the RPM) then takes starts picking up. Think there is a setting I need to adjust?

I will, thanks again. Mind if I ask what controller / radio you are using?

Thanks for your response. I'm in South Jersey - about 2 miles from Cherry Hill Mall (that seems to be a landmark people recognize). I will check the sub-trims and expos when I get home tonight, after a lot of thought last night I think my problem is related to my transmitter settings. Thanks...

Hi, I'm hoping someone can help me. I just finished building my second multi-rotor, this time a hexacopter.....but I'm really a novice at setting things up myself. I'm using the Naza V2, and a Futaba 10J connected by S-Bus. I've calibrated the ESC's, all the motors spin properly but when I try...