Search results

There are usually a lot of 2nd hand ones floating around

I too would also like to know peoples verdict on the best A2 firmware at present. I'm running 2.5. Worth updating?

Great write up dazzab. Any tips for the documents? Submitting mine next week.

Selling off a bunch of pieces I don’t use any more. Send me a PM if you’re interested and I can get you shipping quotes. All prices are in Australian dollars so there is good deals for those people buying with the US dollar. Items as follows… 8 x KDE Direct 4012XF-400 Brushless motors. $100...

Without anymore DJI bashing, can anyone tell me the output voltage of the inbuilt rx? From what I have found with regards to the separate DR16 it's 5v, but I just wanted to see if anyone can confirm this?

The frame is a Droidworx XM8. The motors are as vertical as I can see by eye. I don't think there is any mixings. I've got a Futaba 14SG and it is set to the "Multi-Rotor" class, not "Acro". That should be fine don't you think?

no one?

Hello everyone out there, I'm having a bit of trouble tuning my Wookong, and would love to hear from anyone who has been through a similar situation. My set up is as follows… Octocopter 8kg Camera Ship Wookong Firmware version 5.20 IMU V2 Gains - - - - Pitch / Roll /...

I have struggled with this for ages. Apparently WickedCopters do it, but the are in QLD.

This is large octa, so no aerobatics are being performed. Camera ship. Possible vibration is my main concern.

Just a quick one. What minimum distance do people have the propellors from each other? I am interested in those who run flat 6 and flat 8 configurations. Cheers.

Look out people! Lucky now you can protect yourself with this state of the art Personal Drone Detection System. Finally it's safe to go outside and continue digging my nuclear bunker for the upcoming nuclear apocalypse...

Run the rx on "Mode D", then you can use outputs 1, 2, 3, 4, etc as channels 9, 10, 11, 12, etc, and still have the sbus run the first 8 channels. i.e. your flight control channels.

From memory I think it took me about 6 weeks. I'm sure that we're not that high on their list of priorities though.

If there is threadlock on the screws, stick a soldering iron on each screw and heat them up. That should melt the threadlock, and make getting each screw out easier.

Sorry kloner, are you saying that the inner pivot point is where a little bit of give is which may lead to the off angle? I'll loosen those and see if I can get the arm any straighter.

Cool, so it needs to be corrected. Has anyone dealt with this issue on a droidworx frame before. How was it achieved?

So talk to me about motor alignment. Whilst most of the propellors on my XM8 are fairly close to horizontal level, there is one that is a bit off. Maybe the holes weren't drilled in the booms perfectly inline with each other. Should I just put a shim or two between the motor plate and the...

Which firmware comes with the 2.04 software rentakill?

Putting together a new rig, and wanted to get everyone's opinion on the best, or most trusted firmware for the Wookong Flight controller. Which version have you had the most success with. Is 5.26 any good, or are you still sticking with 5.20 or lower? I will be using it with the V2 version of...