Search results

Alright through testing continuity, I have found that the power distribution board is working as expected. The only issue is somewhere between the positive power cable solder point and the xt60 plug terminal. The issue was that the ESCs were not receiving any power at all. Ill make another power...

I'm pretty sure I haven't calibrated them yet. But I don't think that's my current issue. I have the battery monitor attached to the power distribution and when I plug in a battery, the kk board continues to read 0.0v. Also, when I plug in the battery, the ESCs should beep indicating that they...

Ok I found the site you referenced and so I'll be ordering a UBEC and y servo connector. Basically, there is continuity between the receiver and the M1 port, but the M2-M8 ports are separate. I have a 6 channel rx/tx so ill plug in on end of the y into the rx and the other into one of the ports...

I have painstakingly pieced together my quad, which has taken over a month and today was supposed to be my quad and my first flight ever. However, the stupid thing won't recieve power. Battery is fully charged, and wires are plugged in, but I get nothing. Here is my setup: Kk2.1.5 flight board...

I have painstakingly pieced together my quad, which has taken over a month and today was supposed to be my quad and my first flight ever. However, the stupid thing won't recieve power. Battery is fully charged, and wires are plugged in, but I get nothing. Here is my setup: Kk2.1.5 flight board...

I can't help with the motor choice, but I do know that the KK2.1.5 board is a good affordable flight controller and is capable of acrobatics. There is a lot of content on YouTube about it. Good luck!

Thanks a lot for the great advice! I noticed after some more research that DJI has its own self-tightening props that are good quality and supposed to be used on their motors. As for the FPV gear, I know they work well together because Hobby King designed the plug-n-play kit to work with the...

Hello fellow multi-rotorers! I am getting into the world of mulit-rotors and would like some opinions on the two options that I have come up with. But first, some background! Long story short, I thought I would be getting the quad rotor shown in link (1), and so I ordered a lot of stuff as...