Search results

David don't misunderstand me on this. But i wanted to see your build so i know what i am at. You build is clean and its obvious that you know what you are doing ! I couldn't see anything that would worry me or could be the cause. This is not the issue but once you have the setup going...

I am from Austria Vienna, small country middle europe and Vienna the capital. ESCs concerning timing you are probably fine off with low. You can try mid timing, but than dont go for a flow flight take the bird up in the air take it down after 1 minute check the motor temp and the ESC temp with...

david dont give up ! there is problem somewhere obviously and we will find it. Please make detailed fotos of your build ! Showing how the ESCs are connected and the connection to the motors etc etc. Maybe we find something there ! Boris

this video actually looks good. quite a fast descend towards the end. What is doing the work it the question frame gimbal, post ? But looking at the video on a 30inch i couldn't say it was post stabilized.

Cine, setup some Expo and dual rate on your MX 20. I have 75 on dual rate and 40 % on 4 expo. Giving me a curve like this: Best is to program is onto switches that for take off and lading i can deactivate expo and dual rate for faster reaction again. Boris

Hi Sebastian, schau doch mal ober es möglich ist bei den Graupner Reglern den Throttle range zu progrmmieren. Normalerwise funktioniert das so, das du die Regler direkt and den Reciever throttle Ausgang anschliesst, du auf der Funker auf full throttle gehts wartest bis du ein Signal bekommt...

Not really problems with vibes, except last time were i tried the axi mounts on the QCs. Although they look the same for some reason i got a lot of vibrations with the axi mounts. Liked this approach so i added the kopterworx plate.

vid explaining the hack patch procedure :

Hi aWandere, may consider those http://www.hobbyking.com/hobbyking/store/%5F%5F20740%5F%5FTurnigy%5Fnano%5Ftech%5F5000mah%5F4S%5F35%5F70C%5FLipo%5FPack%5FUSA%5FWarehouse%5F.html Cheaper lighter and C rating shouldnt be an issue. I have 6 packs of them 4s 6000mAh and not problems since 4 5...

HI Bart, i personally certainly fell for the thought that the V2 might be better than the V1. Back then ordering them though i explicitly expressed that I will be using them with WKM thinking bluntly that they have to be compatible with most given motors used in the MR scene. Things changed...

I am just noticing that the high idle speed is linked to how high your basic gains are ! Start my C8 with 300 % plus results in a much higher idle speed than when i keep it down to 100% and bring it up later. Boris

Anaka thanks we will see when the cards arrives, but Geoff is not getting it to work the the 88 mbit unified so i guess I also wont have any luck if i dont change some addtional settings. Guys it this the right approach ? I get the unified hack loaded than i tweak the setting for 720p60 GOP...

Hi Matthew, Its a litle bit of a mess in there, because of the backlight canopy and i want to keep the motor wiring max length so the motors can be used as spares for my CS8. The IMU is directly over the Herks and i dont have any problems. Boris

hmmm sorry verwende ich nie habe spannungs überwachung komplett ausgeschlatet fliege mit: http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=10343 kann mich aber nicht erinnern das es eine Einstellung gibt :( vielleicht vertical wie gesagt,

puh du meinst failsafe landing ? Ich glaube das gibts keinen, es könnte sein das sich vertical gains drauf auswirkt aber ich bezweifele es. Hast du es schon getestet und er sinkt zu schnell ?

Hi Fritz. Du musst dich mit dem Basic und Attiude gains spielen. Am besten legts du die Basic gain roll tilt yaw of die Funke and auch attitude mode roll tilt auf einen zweiten Kanal. Dann während des Fluges verändern vorrangig mal Basic gains von 100% rauf bis du merkst das der ganze kopter...

state clearly to them which motors you are planning to use with their ESCs, from experience i would recommend V1 Boris

Hi Thomas, they look like V1. The V2 have a extra little red or yellow star on them stating V2 which i cant see on the sticker of the min the video Boris

who am I the chevy chase guy ? :)

im out bar hopping tonite ;) whenever i come to life tomorrow and i find the right settings ill make a video of it. Boris