Search results

Not yet, I have ordered a new ESC which should arrive after Chinese new year, if this is successful I will let you know.

Thanks for the response, I will buy a set.

Did you get any luck with these? I am considering buying a set.

Yes, getting the normal bleeps and flashes, also no error messages when connected to my PC via the assistant software When I tested directly with the receiver I first plugged in a servo to make sure I was receiving a signal, I used the same channel with the ESC. I will test the large...

I tried connecting the ESC directly to the receiver and have the same issue so I do not think it is Naza related. Anyway to test an ESC?

I had a similar problem when using a Class 6 card, the video would stop after 6-7 minutes. Switched to a class 10 card and no problems.

Hi, thank you for the reply. For the radio I have a Futaba 8FG Super and the Futaba R6208SB receiver, connected to the Naza using S-Bus. This seams to be functioning well as I can see in the assistant software that all the sliders are moving normally. No other errors in the assistant...

Short Update. I have tested the Naza and the Receiver, these all seam to be good. I also tied to drive one ESC and Motor from the receiver, eliminating the Naza and I got the same jumping results so I conclude the Naza is Ok. Next I used a power drill to drive each of the motors and check...

Hi All, I have just received a new frame (tarrot 680) and decided to move all my Flame wheel 550 DJI equipment over (motors / DJI ESC / Naza) over to the new mutlicopter. I had everything assembled and double checked and powered up the system. The Naza went though the normal beeps, I then...