Search results

How are you going with this Have you tried another RX? When you said you started a fresh model did you re-bind each time you did this Just thinking it may be the model match function on the TX not recognizing the rx as it may think it belongs to another model

Take it back to the shop you bought it from if it is relatively new

You obviously have the flight battery connected to the 550 and the RX is lighting up to show it has power you hopefully have props off , when you have it hooked up and it shows config err try unplugging the cable and re-inserting it whilst the flight battery is still hooked up Maybe try a...

The Naza lite is locked to an early version of firmware and the early versions were not recommended for anything over 650mm according to the early manuals Also see note 1 in the red ink on page 6 of the LITE manual...

In the assistant under the "BASIC" and then under "RC" tabs there is a selector for input type in relation whether you are using traditional wiring or s-bus(dbus) or ppm is this selected to what you have (if you have several wires from rx to Naza it should be traditional ) also you will need...

Carbon fiber can and will block radio waves very easily it basically has no RF transparency This used to happen with my T-Rex align heli's with Spektrum radio gear with carbon frames If your receiver aerial is above the top plate and can't be seen from underneath it may well being blocked...

It sounds like your RX is not bound to the TX or the esc's are not plugged into the RX

Just making sure as most newbies I have met only arm the motors when they go to fly for the first time Hence all the my quad keeps flipping on take off posts due to incorrect motor direction that was never checked previously And if it does arm when he has the throttle at the high point due to...

Tiger motor 2212-13 980KV will run all day long on 4s with good 9X5 props APC MR props I know as I have been running them in that configuration for over a year now at your weight I would not run them for too long on 4s with 10 X 5 props they will over heat but would be fine with 3s on 10x5 props...

DO NOT DO THIS WITH PROPS ATTACHED for very obvious reasons

I have had 3 spektrum radio's and last year I changed to Futaba T8FGs and it was the best money I have ever spent on radio gear in the last 30 years of using R/C gear It is far more user friendly a hell of a lot more intuitive with more programming options , all but 1 switch is a 3 position ...

Did you do the "control stick command" to arm the controller Usually both sticks down and to the center arms the controller then the throttle will work And as it is a V2 it will remain at idle speed (spinning slowly) as long as the throttle is above 10% and will ramp up only when you get to...

Well all I know is that calibrating my ones made a huge difference , I use a T8FG radio

@ Kloner I have a set of 30A simonk speedies and until I did a throttle calibration on a full throttle climb it used to try and flip over to the back left after a calibration it now goes straight up no trying to flip with no other changes to the quad (QAV400 with tiger 2212-13's) these ones...

Also be wary as that rx is only a park flyer rx not full range keep it in close the range on the one I had many years ago with a Dx6 only had a range of about 200 to 300 mtrs in a rural enviroment on a good day the fail safe is preset to low throttle on signal loss

I use a set of these Quadframe legs http://quadframe.com/collections/legs/products/155mmll They have survived a few hard knocks and firm landings and still going strong As seen here fitted with a few pieces from the option 3 set from your list all works perfectly jello free

I have 3 Naza f/c's set up this way and they all work as described and they all "RTH" when forced fail safe is activated using a Futaba T8fg super http://www.youtube.com/watch?v=ck3tu-4UVgg http://www.youtube.com/watch?v=SmDehc5PEUQ Credit for the video's goes to the author they are not mine...

If you can't stomach loosing your gear then maybe this hobby isn't for you If it flies it can be lost in several ways flyaway major crash with total destruction crash into deep water crash onto Hi-way Every time you fly any one of these is a possibility Also putting your name and number...

The Naza m v1 will work just fine with the mini IOSD and the V2 PMU I have a QAV520 with Naza v1 with v2 pmu and mini osd And a DJI550 with the same setup both running 4.02 firmware they all play together well with the exception of having to use the v1 vu/led or hack the v2 led to get it to...

It will move around usually within a 2mtr circle on the horizontal and this is totally normal They will move due to outside influences like wind both up and down and sideways Have you done the GPS dance to calibrate the compass ? My Naza lite moves around more than my 2x Naza v1's with...