Search results

@Daniel : Sorry for 17hr delay in replying. Picloc-3X supports 50,77,100,250,333 and 400Hz update rates. Now, 50 and 77Hz are aimed at users who are using analog servos on their camera mounts. Analog servos are not designed to run at much higher than 77Hz( probably 100Hz max ). Otherwise they...

MKS HV-787 is my preferred servo. 2nd is the Spektrum H6040 if your camera is smaller/lighter. Both these servos exhibit relatively good characteristics for stabilization at entry level** The output from Picloc-3X is really fast and instantaneous. The Servos need to act as fast as well, but...

@Tammo, You can route any TX input to any Picloc Output through your servo output matrix. Just select which RX input you want to see at your Servo output, from the drop down menu in S1 to S6. @HexaCop thanks for the comparison. What servos are you using on your mount ?? Still seems a bit too...

Yes.. Sure! Contact me by email 1 day before so that we can co-ordinate a meeting.

As for the swapped ROLL and TILT ( if using Tilt in Arrow Direction ) ... this is fixed already in v0.56 which I'm working on. For now, please make a mental note that these are swapped if Tilt is in the direction of arrow on the Picloc Case.

Hi Jesper, This function is related to a single channel, Aux1 Depending what radio type you have set in the Options tab, AUX 1 will command an E-Stop if your selected channel is taken to one side, or bring your 3 axis to saved "home" positions on other side of your throws ( Stick, know, or 3...

Cannot give an exact timeframe. However, it is one of my priorities.

>>Regarding the mounting orientation, I am a little bit confused, could you please try to clarify?<< OOps.. my mistake... Right now, only FLAT with Arrow direction being Tilt/Roll is possible. I'll try adding both Portrait and Landscape modes. The orientations possible will be limited at...

I do not have that radio, nor plan to purchase it. However with your help, and 1/2 hour on skype, I can probably make it work and add it as an extra radio system to v0.56.

Hi Jesper, in v0.56 firmware and Toolz, it will be possible to mount Picloc in Landscape ( pins pointing down ) and also inverted ( USB facing down ) so that people using Picloc on mounts with 360 servos, can attach it to under the camera plate.

LOl..... Yea !!! No coding till we 'slide' to next year . Good 'Slide' to you all :)

@redridinghood: yes.. you can do that.... but I prefer to put in one of these for fine trimming. I drill a small hole on the side of the servo for access to the adjustment screw, and then hotglue the pot inside.

@Boris, I'll leave your replacement on a burn-in test overnight... then I can say that " its been working since last year " ;D @Holco, HV-787's are very modifiable... just remove the pin limiter using either heat, or else DJ's drill chuck technique. @seattle_helo, The unit that Boris has is...

Hi Denny... early riser....I'm off to sleep ;) Piclocs are being built for persons who pre-ordered them. Still unclear when next batch will be made.

@hexacop .. yes reduce the acceleration. FYI.. acceleration is sensing and predicting movement ( in your case .. because you are using Proportional Servos ) Therefore, its increasing the nervousness of the stabilization artificially, compensating for the servos's slower speed or lag in their...

Hi Guys, I found this forum, and this thread. Thanks for sharing the experience. It's 4:45AM here, and we're still trying our best to build the last few remaining Picloc-3X's for customers. !! Please forgive the basic support I'm giving right now to you guys having some issues. Most were...