Search results

I went with the voltaire cuz im running a wookong m and esc's

Yea it was good, found em as a us dealer from the hobbyking site, at first it was a pain in the *** because they didnt accept canadian paypal... Wtf i thought, semt em an email. A couple days later i was good to go, ordered 6 30amps w/card just ordered 4 more tonight for my fpv quad

I tried the warp and still have it. Bit i had lots of croping happening video was zoomed in like 40% any thoughts?

Im building my ad6 and have gotten voltaire boards from multi wii, i was going to go the power dist manifold route before but i decided to give these a shot, i will b splitting the load so 1 board has only 3 esc's to be safe it doesnt see excessive heat, if one day my hexa falls due to pdb...

If u are in the states i got mine here, FalconSEKIDO.com Us distributor, best prices i could find

wondering if 10" props are too much for these? I know it will spin em but will they get hot Would they be better of on 8 or 9 " props... im still learning about the whole KV business

Very nice Ken, is that on a nex5n? Ive been debating wether to chang to the new firmware, im about to fly my new ad6 hl in a few more days... Looks promising

http://vimeo.com/41702580 Found this tonight!

I turned it off and fly by timer on my radio, be sure to do a test flight for 5 minutes and see how much mah u put back in then u can figure how many minutes u can fly

they will physically fit... see how the motors do temp wise

Pre ordered one myself aswell, I have no experience with hoverfly but am trusting their history. If it blows ill try and return it, if not i have a 300 dollar gimbal controller for my smaller quad and ill have to buy another type lol

Hey fellas, I want to set up a mix on a two way switch... Id like to program a mix for gear to gear so i can trim it by like 25 points when switched and activate a failsafe on my naza. I know where to program it but i cant select to mix gear to gear only gear to another channel, i did it on my...

I put a tslrs rx in it, ill do my best to figure out antenna layout as they are both about 16 inches long, id use my spektrum gear again and i will be when i finish my AD-6 which is the tslrs's home but i just read allover that spektrum doesnt do well with objects blocking line of sight, ill...

Verified, 5.14 found my multimeter. Thanks

Rebuit with long range Rx, gotta install my FPV cam and start into a new adventure. New RCtiger motors, didnt want to cut the wires shorter... never know if they will be transplanted to a different rig

Im going to be wiring up my lrs rx for some low cost test in case of failure/signal loss, What kind of voltage does the naza output to the RX, For my system ill be needing 5-6 volts. Should i run a BEC and use leads i have that only offer signal or will the naza with standard wiring b ok? Thanks...

Ive just put on the rctiger motors and love em. On 4s with graupner 10's and its almost too much to handle in manual, atti mode is great

Where the hell can i buy one... Let me spend some money lol

I ended up going with the multi wii voltair boards.... I ordered 2 so i can have 1 for another build or if i decide its cheesy ill use one for three motors and the other above for the rest Thanks for the thoughts guys

I need a dist board for my ad6 HL w/ 30AMP esc's and axi 2814/22 motors.... anyone known an american dealer for these or similar? i dunno how or what i need to make my own, ill take instructions and a parts list on that too lol ThANKS