Search results

  1. Y

    Receiver Binding DJI Phantom v1.1.1

    I solved it changing receiver 1.1.1 (it can be receiver from Phantom 2 with two antennas). After i binded it with transmitter. And its ok, no yellow LED any more. Pacomachine, check type of RC in NAZA soft, it must be D-bus. Hope it will help
  2. Y

    DJI Phantom 1.1.1 Transmitter problem

    There was CFG-ERR, i did everything, reseted settings, and after this there's gps calibration error, i cant calibrate it because of no connections to transmitter. I already ordered new receiver, hope it will help... but why? will happen again? during flying? omg...
  3. Y

    DJI Phantom 1.1.1 Transmitter problem

    No, you didnt understand. If i plug in NAZA to soft - there's no action from stick. And no lighting binding LED on receiver (even if i press and hold for a while small button). If i plug in transmitter to RC soft - its ok, sticks are in action.
  4. Y

    DJI Phantom 1.1.1 Transmitter problem

    to hook what? transmitter? Yes i tried, and its ok, i see the action in RC assistance software, so transmitter is good. But my receiver is not working, to hook it up to computer? how?
  5. Y

    DJI Phantom 1.1.1 Transmitter problem

    I've ordered new receiver. Hope it will bind with my stock transmitter. Receiver is dead somehow :(((
  6. Y

    DJI Phantom 1.1.1 Transmitter problem

    Hey all. I have an Phantom 1.1.1. Receiver has two antennas, X1, X2 cables, NAZA is yellow. after power on and diagnostic there's yellow LED is blinking. Means no transmitter, or error. NAZA soft shows CFG-ERR, Configuration error, this may cause by firmware upgrade from old version.or abnormal...
  7. Y

    Receiver Binding DJI Phantom v1.1.1

    What if there's no LED blinkning after pressing small button inside the phantom? Base LED is Yellow blinking and cant use transmitter. how to solve the ploblem?
Top