Search results

This looks like a good one. http://www.amazon.com/Screen-Sunlight-Readable-Monitor-Samsung/dp/B007D48W2O

The version one work with PAL signal only. The ver 2 works with NTSC and PAL from what I hear.

Get the version 2 board for NTSC. http://aerialmediapros.com/store/product_info.php/zenmuse-hdmi-converter-board-gh2-p-320

Has anyone tried these on a S800 with a gimbal? I like the fact that these have a larger bearing in them.

I found that opening it up and making sure the circuit board is centered helps.

I haven't had an issue with them yet. I even sent back a bad vtx and they refunded the cost. You should get on the live chat and talk to them if you want a quick response. I don't expect any customer service for the prices I pay there.

The magnetic one is to small for 15" props. +1 for the Du-bro truspin.

was the video recording?

Found this on the rc powers forum a while back. http://www.rcpowers.com/community/threads/how-to-choose-a-lipo-battery.10855/

Flew the S800 wkm in 15-25 mph winds with no problem.

That is the camera/gimbal operator doing some sort of chicken dance.

Thanks for the compliment Peter!

A short Show Reel of sorts. S800 Zenmuse GH2 http://www.youtube.com/watch?v=kgklfjKd2jU

Make sure your equipment matches frequencies. CH1-5705MHZ, CH2-5685MHZ, CH3-5665MHZ, CH4-5645MHZ, CH5-5885MHZ, CH6-5905MHZ, CH7-5925MHZ, and CH8-5945MHZ.

3 min flight on 5.16. It seemed a lot smoother with the new firmware. I still have a bit of hunting from the zenmuse.

That was the problem... Been flying with B&W for the past 2 months.

I have had the occasional white flash and some green flashes on the ground. The green flashes started after I made a common ground for telemetry. I'm thinking about reconfiguring the receiver setup to just run off the battery. I got a loaner GPS with the tabs while the new one comes in. I See...

You will need a e-clip remover to do it properly. Remove the motor from the frame and desolder. You need to scrape off some of the conformal coating to desolder it. Pull off the e-clip and the shim washer. Then you can remove the bell housing. Pulling out the bearings out is somewhat of an art form.

What are some other prop adapter options that have worked on the S800? I would like to run graupners 14x8. Excuse me please if this is the wrong place.