Search results

I don't know for a fact that I "should" be seeing movement, but seems like I should. The highlighted red sliders in the LCD display don't move when I move the sticks.

The channel page has horizontal bars which show movements, yes. When I move the throttle, #1 and #9 display the movement. I will try hooking up a different esc tonight or tomorrow, to rule out one bad esc/cable.

Ok latest update: I rebound the TX with the jumpers. Communication between the TX/RX seems to be fine. I then did a TX calibration as per the youtube video posted here. Checked throws and they appear to be proper at 100% when all the way to any side. As suggested, I ran an SBUS connection...

Found 'em. They were hidden in with the keys. I'm going to do a TX calibration then rebind using the jumpers, just in case.

Correct. I did not see any jumpers in the packaging. I'll take a closer look. The RX was just "in" the case with the TX.

Talking about the jumpers used in the binding process of the TX/RX. I'll reconfig so the superx is getting 22.2v directly from the PDB and I can apparently save a few grams and get rid of the voltage regulator. Thanks. I have some work to do and will let you know. I'm sure I'll have more...

Na I clipped the servo wires to make the jumper cables. My ESC's are not opto. They have a BEC on them if I'm not mistaken. I'll check the obvious later tonight, like maybe having the servo wires upside down. Pretty sure they only fit one way though. I'll mess with it more and report back...

I never answered this. Sorry about that. I'm running the Tarot 5008/340kv with 40A-PRO hobby wing escs.

I'll do that next, hopefully late tonight. Yup, throttle still copied to 9. Both channels show on the monitor when I move the stick. Jumpers removed yes. Green on RX yes. Are you talking about the cut servo wires when I jumped it? Or are you talking about cut servo wires which go to the...

Checked: Radio set to D16 internal. Channels set to 1-16. I took two servo cables and cut off the hot and ground, leaving only the signal cable, and bound the RX with channels 1&2 jumped and 3&4 jumped. NO cables are attached to the superx, no sbus connected. I turn on the TX, then move...