Recent content by tyor

I have the same problem ????

maybe bad conection between a motor and a esc. ?

have you adjusted the endpoint for the servo in the assistant program? Then it will not try to move the servo longer than it can be moved.

ok, but I sendt them a mail and they said it was 8mm holes?

is there someone who have tryed these props on f450. they have 8mm holes, so they should fit the dji motors. http://www.electronicarc.com/catalogo/product_info.php?cPath=85_90_124&products_id=825&osCsid=3ab9351e0ae0e484b4b48026becfc2fa

some shots of the automn in Norway :)

when you have the trottle in center it wil hover. if you lover the trottle little it will come down slow. the more you lower the trottle the faster it will go down. the same when you rising the trottle. more trottle gives more speed.

I have red light on mine. but it is seems like it is woorking ok ;)

I use the balanca leads every time. becouse if there somthing rong with one cell the charger vil stopp the charging. even in quick charge ;)

I got futaba s3150. before the upgrade the tilt servo would move a little upp and down when I was hovering. Now it seems like the servo got better resolution.

I upgraded too. and the gimbal seems mouch smooter now :D Have to test it :)

It seems to woork ok now. i looked att the monitor on the radio and itt was perfect there every time ;)

http://www.dji-innovations.com/products/naza-multi-rotor/downloads/ :nevreness:

I tried to recalibrate with no subtrim today. 5 of 10 times. the elevator slider in the software was standing a bit left of the center. not more than it was green. but it vas drifting backwards when i try to fly. both atti and gps. When i got it exactly in the center it was not drifting. I...

it is 2 years old. its a wfly wft09sII. Never had any trouble with it. I wil try a bit more tomorrow. on another forum they say it is a bug in the program, and it should not happen if I take out tha battery and try again. I will make a report here later.