Recent content by tumad

Sorted. Lose switch wire.

Hello Everything works a treat except the Home reset via X2 (IOC) switch. I find that if I haven't used GPS mode on that flight, I can reset the home position by flicking the X2 (IOC) switch 5 times. However, if I have started the motors and used GPS mode, it won't reset. My configuration is as...

still for sale?

hello it is with interest I am following this. I have a question regarding the phantom. does it have that insane power due to the 8 motors? I thought the dji system was limited in power output? pls explain. many tthank also please post. Of detail to the CFO tube mount on stock dji ararms...

Hello and thank you i think you are missing the point or I did not express myself clearly I cannot connect ecc to correct output Chanel. My receiver only has a single cable (sum) coming out which goes into Naza port. There is no option to connect something into Chanel 3 or where ever. They...

Hello all. Not sure if this has been addressed before but how do I go about calibrating the throttle range using an S-bus receiver on a Naza unit? I do not have the option to connect each ESC to the receiver directly as it only has the S-bus connection. It is a satellite type receiver with only...

independant 100%

I use high performance HITec servos without any issues

This might sound obvious, but did you check your actual servo? Even if it is new, try another servo on that axis and see if it jitters. Also, if your supply voltage is to low for the servo, you will experience jitters. Make sure your supply lipo is sufficiently charged. You might want to try...

Most of the movement is from the GoPGro that was loosely mounted onto the leading arm with only elastic bands for this demo

It is the HoverflyGimbal controller we are concentrating on here

Nope, best investment I ever made..

HI I have had both, both fly identical i.m.o. but need slightly different parameter setups (cant copy setup parameters one to the other) Hexa has somewhat of a redundancy, quad has none, hexa can lift 1.9kg easy, quad about 1.2 kg. if the question was between a standard hexa (robbe motors 10"...

Just ordered one for my 3 axis cinestar, lets hope I didn't waste my money..

Hi all I have noticed that no one has mentioned the APC 10x3.8 or 10x4.7SF range of props as used by a few other multicopter manufacturers. Does anybody have any experience on using these on the standard motors with either 3 or 4s batteries? I am assuming a F550 with at least a 4000mah...