JJdac, look at the settings listed on page 2. I tweaked forever trying to get the jitters out of my Gimbal and only solved it by using the settings recommended there. It seems that tweaking the by trial and error is an act in futility.
I also have the same issue with the gimbal freaking...
Johnnie, read through the first few pages of this thread (I have had a long day so I'm far too lazy, also my gimbal is sitting on the shelf during my current re-build)
Basically I would suggest bypassing the Naza all together. Look into your futaba settings and find out what output your...
I have had this same problem. I ordered big bags of M3 and M2.5 from fastenal (http://www.fastenal.com/web/home) if you have a local store you can actually take the screw in that you want and they will look it up and get it shipped in. They usually have some M3 in stock and have to order 2.5.
I...
Can you post a link where I can download the latest firmware? I'll be mounting the gimble on my newest build soon and expect the will be a good time to update.
Thanks!
....yes, it can be driven from one channel on the Rx, you want the signal from your knob to go to the "T" pin on the tarot board. I ran the negative to the negative pin on the next row down. Positive is cut off and sealed in shrink tube.
The instruction I read when I connected the board recommended running a negative to one of the negative pins on the tarot board. With the layout of the pins I couldn't connect the RX to the tilt pin and a negative pin without the split. I think some where back in this thread there were...
I haven't messed with updating the firmware at all so I can't help you there, sorry.
I don't know much about the Phantom set up either, alot of the 6-7 channel radios have a knob that people use for the tilt adjustment. I think one of the videos said it was the first video that wasn't using...
Xaircraft,
I just uploaded your gains and they are way better than what I had. went in and messed around with my motor setting and have the Gimbal working perfectly now. All the issues are basically solved, at extreme limits I get some vibration but I would have to fly pretty hard to get...
Sorry to hear about the crashes, unexplained problems are the worst because you can never stop worrying about them.
On to my point.... my Quad is flying a Naza-M (upgraded to V2 firmware) and I have found it very reliable. I fly mostly in GPS or ATTI mode and as soon as I'm ready to come...