Recent content by sscherrer

Ok so went out yesterday with another guy who has a 450. We flew mine (so to speak...) it does stay stable at 1cran above 50% and v2 is working as designed, but 1 cran above and it starts jumping in the air. It can descend as well, wich is reassuring. So essentially too powerfull and sensitive...

Hello all So... I took all my courage and went out for a flight test. Fortunately it did not do like first time, however, really have an issue with the speed control. in ATTITUDE Mode, CSC, then 50% throttle. Quad is at ground. I push a little bit, it takes off... so far so good, but then...

Manual works perfect and considering each motor are well in sync... don't believe the throttle needed adjustment. I know notice says it...but it's not SimonK Yes all looks fin in GPS and Atti and obvisouly it sees it at30%...check my finding... quite strange but all ok now.

All, Thanks I believe it actually works as designed and no need to recalibrate. After the first explanation on the assisted take off... I tried again this morning AND... - Once you pass the 50% mark, if you do no increase sufficiently, the motor speed will not reduce below 50% throttle...

Hi Pete Most of parts are listed in original post I believe : - FC: Naza V2 - latest fw - 4 RSC : RCX 40A from myrcmart (http://www.myrcmart.com/rcx-40ahv-hi...re-p-6442.html) - 4 motors : (http://www.myrcmart.com/rcx-be28149-...ty-p-6488.html) then - All rests 3d printe from...

Hi Just completed a new 550 build (3d Printed). I have used brand new Naza V2, 4 RCX ESC 40A from myrcmart (http://www.myrcmart.com/rcx-40ahv-high-voltage-26s-opto-esc-series-programed-for-multicopter-simonk-firmware-p-6442.html) , 4 motors...

Hello all I recently started building my own drones. Since I do 3d Printing I started with the small Hovership and enjoyed great flights. I as well designed new upgrade improvement for it to beneift the community. I have just completed the build of a second 3d printed quadricopter based on a...