Recent content by sscharnell

SO I thought maybe if I didn't use D-bus and ran the individual wires I might be able to get this going. I had to look up how to connect the wires and realized I did not have the wires run correctly for D-bus changed them and the error code is gone. Thank you for your time and help.

I pulled the "guts out because I thought that is what you would want to see I pulled the "guits" out because that is what I thought you would want to see. Motors are on M1 to M4 Receiver is on X2

I followed the directions and still just the error msg

I am very new to this so my questions my be dumb. If by calibrating the transmitter you me binding it to the receiver it is. but I still get the same CGF-ERR error.My transmitter is a Taranis Q X7 and the receiver is a FrSky X4R.

Here is what I have tried so far. Remove and reinstall the drives and software making sure the drone was on and connected to my computer. The computer is running windows 7. When I try and use the assistant I can test the motors and check the battery pack voltage that is all. At the bottom left...

I am getting the dreaded CFG-ERR

I have a NAZA M V2 with a FrwSky X4R and Taranis Q X7. when I try to power up it goes right into failsafe. When I try and connect with a USB to the assistant I get and error msg. What do I do to fix it? any help would be great.