Recent content by specksturm

Yes I do get the correct beeps so everything should be OK with the calibration. And yes I have had issues with the ESC's uncalibrating them selves now and then. I first thought you ment that they somehow can unprogram. So that you have to do a re-flash of the SimonK firmware.

Ok, I didn´t know that the ESCs can uncalibrate themselves. I also start to think that the twist in the frame is causing this problem. Can you explain more in detail how you calibrate your ESCs using the rx? Is it different from the routine when you push button 1 and 4 while starting up with...

Hi! I use a kk2 board on the following quad. Foldable H-Frame (wood) 47cm between rotors T-Motors 2216-10 (900kv) props 11x4.7 25A ESCs (simonK) Different kind of Lipo 3S RX Frsky 8rD II plus TX Frsky DJT motor setup: X Yesterday I was out flying with a camera on the nose of my H-quad. I got...

Hi! Sorry for not updating and answering in this thread. I gave up with the old board and bought a new one and got it up in the air. The ESCs were all calibrated with the kk2.0 board. But one motor is still behaving a little bit strange when starting up. But when cranking up the throttle it...

Hi! My setup is: Foldable H-Frame (wood) 50cm between rotors T-Motors 2216-10 (900kv) 25A ESCs (simonK) KK2. controlboard Battery Zippy 3S 2800 30A RX Frsky 8rD II plus TX Frsky DJT I had some problem in the beginning when i tried to start it up today. Motor nr1 was not reacting in the same...

Hi to you all! :) I´m totally new to rc flying and quads. On the other hand I have spent hours on reading and watching material on quadflying and building. I didn´t want to buy a ready frame or ready to build copter so I just finished a foldable H-Quad inspired by this...