Hello my names is Ryan and I am finishing up my degree. Also a drone / fpv hobbyist and I was hoping some of you could help me with a 3 question survey. Looking to gain some insight as to where everyone is spending and there geographic location.
3 Question Google Forms Survey...
Brand new in box Enerland Co., Ltd. 7s 5500mah XP 35c lipo batteries, these are some of the best possible batteries on the market. Enerland is know for over 80% retention at 500+ cycles and Good Performance at Low and high Temperature ENERLAND, established in 2000, leads the technology of...
Brand new DJI Ronin and Lightbridge configured and ready to go, includes Flysight HD monitor and mount for Ronin remote. $4150 shipped inside USA. Brand new, fully configured and ready to go. Will go great with the upcoming S1200! Open the box, power it on (Lightbridge and all). All hardware...
http://www.ebay.com/itm/291183071079?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
No longer includes 5.8tx rest is there.
2 of 1.3 1.5w vtx (only one in photo shown) both are brand new never used INTERNATIONAL VERSIONS!!!!
Channel 4:1080MHz
Channel 5:1120MHz
Channel 6:1160MHz...
http://www.ebay.com/itm/291066022561?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
Selling a ton of old fpv frames and parts. Everything in working order las time I used it. Some assembly required and most parts included. Gimbal needs replacement motor installed but is included. One...
This setup has been built from the ground up for cost effectively out performing and out lifting other ridiculously over priced systems (Cinestar, Droidworx, etc) on the market.
Everything listed below is included, and the entire setup is very self explanatory. If you are looking for a...
Up for grabs, around 10 flights and my second large build. 12+ years in software / hardware dev and 20+ in RC. Easily outperforms 15k Cinestar setups for a fraction of the cost. Serious inquiries only, I will not part out, bank wire transfer only. Optional 2 * DX7s's bound and ready to fly /...
I am also having issues: here is a thread on another forum http://www.rcgroups.com/forums/showthread.php?t=1916955#post25366652
Any help would be great.
Currently struggling with a similar issue: http://www.multirotorforums.com/showthread.php?12061-Wookong-M-Octocopter-gain-settings-and-issues
So, increasing my gains would make the flight controller more sensitive correct? If that is the case wouldn't that change make it harder to fly? I guess...
Hoping you guys might be able to help. Yesterday i test flew my octo in almost no wind for the first time. I was running the same motors and esc combo on a hexacopter which worked great but now im having problems. My gain settings are 100 across the board in the dji wkm settings but the copter...
Lightly used dji naza GPS. I am upgrading to wookong m and no longer need this. Perfect working order and latest firmware
http://www.ebay.com/itm/290914007600?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
PM me for buy it now, or bid to win :)