Recent content by Neil4rc

I've had 2 further flights and no errors yet. I may try lowering it a little as currently I can't fit the canopy.

I thought I'd try raising the GPS and the first test flight was positive with no magnet 22 error. I will attach my camera and try again tomorrow to see if it's still made the difference. Fingers crossed.

Hi Dave I'm not really in the right thread but the magnet error 22 is applicable. I'm getting an error within minutes of take off and at times the copter will make large circuits (I'm guessing looking for a coordinate). I'd like to try relocating the gps but haven't found a ready made solution...

Unfortunately quadrocopter.com couldn't help with my Droidworx Hexacopter, I'm guessing the booms must be narrower or something. I may try a pipe or hose clip and see if I can make that work

Sounds like a must, does anyone sell a mount to relocate the board?

That's very helpful, I'm going to give it a try. Thanks, Neil

Any chance you could upload a photo of the shielding you've done? Is anyone using a magnet attached to the power leads? Many thanks Neil

I lost mine in flight on about its 3rd or 4th and also lost some camera settings. I re ran the saved configuration on the mikrokopter tools and it's done about 5 more flights without doing the same. I am however suffering from magnet error 22. Neil

I'm having similar problems with a hexa and ar200 mount. The magnet error starts a minute in and during this time it will hold a gps. The alarm on my mx20 stops around 5 mins in and then restarts a minute later at which time the copter will do a very large circuit of about 30-40 meters.....which...