I do not have a lot of knowledge on Open Source Software... If I updated the Board when there was already a firmware installed its glitches?
Here are some Pictures of the connections between the Rx and the Board.. and the cables...
If having a couple of firmwares on the Board makes...
Well... Everything seemed to be Alright at the beginning.. But right now when I make rough movements the Gimbals seems to glitch and goes kinda crazy.. I have installed those 3 firmwares on the board... is it glitching because of that?
The äbsolute"box on the rc control in the Gui is checked...
I am having so much trouble with this Gimbal that im getting depressed.... I Have done successfully All the instructions previously mentioned to try to make my Brushless gimbal work... I Installed correctly Arduino program so i can Update the firmware on the board So i could control the gimbal...