Recent content by Large

Post up :D South East Houston here.

Yes thank you for the help. The A/E/T/R are all 1-4 in the Tx. I have another naza coming along with another receiver and a new hex build I am going to start. I will keep trying to get it to work correctly with the s-bus until I will just give up lol. Thank you again for the help buddy.

I did put the rx back on channel B, I also did not see a write button on the naza M lite assistant program. After I change a numerical value it tells me to press 'Enter' to write, but changing an option (like for instance Tradition to D-bus) I do not see a write button for that. Maybe the Naza...

I was merely following 8J guides as there were 1 or 2 - 10J guides out there to set the stick calibration (not in English either lol) so I had to work with very little. Everywhere I saw it said use acro, when I exhausted all my options I did try everything on multirotor and still had the same...

Yes on the receiver, receiver was set to acro I think and yes the Rx has the green light showing it is communicating with the Tx. I've tried all 4 channels as well and paired the tx/rx a few times.

First off - hi! This is the 3rd forum I am going to give a shot at getting an answer from so bear with me if you will. I am building my first hexa and wanted something simple so I went with a 550 frame, 2212 motors, simonk escs (30a) naza M lite and a 10 channel futaba rx/tx (T10J). The only...