Recent content by kjetilhansen

Yeah, my setup as we can se on the picture is 2 ubec on the same battery, one with 5V to skyline, and the other with 7,2 to the servos, when I power up this the servo roll a bit to the right and then starts flashing red.. But I will try 1001 Copters tip, I will twist the ground wire together...

Does anybody run the skyline with high voltage? Or just 5V? But as i read in the photohiger manual 5 volts are max, but on a webpage that sold it, the max voltage was over 7 volts, witch is perfekt for high voltage servos.. I made a "help me thread" would be great if sombody could help me out...

Is there any other way I can run high voltage on this without that harness?

Hello! I have been following the skyline thread, and thanks to that thread, I now have a working AV200 with skyline :) Buut, it's still on "low voltage"... I have a cable harness that came with the skyline, please see picture: This is the harness that came with the Skyline... I have...

I belive I have the exact same setup as you, included the DJI esc's, it works fine with me, but I must admit, it's pretty scary to use these cheap motor controllers with such an expencive setup... But I don't know about any better controllers.... -Kjetil

Thank you. This tells me all I need to know, and didn't know... Can't wait untill im finished on work to test this out, one week left :D And I am happy to read that photohigher are hireing sombody to make the instructions better, cause there is no use even reading it now...

They have alot of problems, they really do, but I still like the skyline when it works :P My only problem is that I havn't had it working myself since the manual for installing skyline is really bad... Does anybody have a better schematic over hooking up the new version of the cable harness...

Hang the copter? I have it standing on the 360 kit... But I manage to fix some problems, but I still have one left.. I managde to fix the z axis, but now the roll isn't working, it maxes itself to the left, but when the autotune is in progress, it tilts also the other way, and when the...

Hello! I am trying to setup my av200 with skyline, and i followed the instructions, but when after I set level x&y, and Z, i save, and press autotune, the z axis (pan) starts spinning over 360 degrees, yanking out the cables attaced to the av200... What can it be? I have removed both pots as...

So you will get better pictures with an SLR? I primarily want to take stills, but I would also like to make a decent fulHD film..

Hello all! New at MultiRotorForums, so hello! :) With me i brought a question :P I currently have a droidworx ad 6, with the av200 gimbal. I now need a camera. I friend of me told me that there is no use for a SLR camera, cause the Nex5-n does the same job... I then wounder why do some of...