Recent content by Jaybeast

Selling a used Gaui Crane 3 camera gimbal and DJI F550 mounting plate in great working condition. Asking $200, which includes priority shipping via USPS to conus. This gimbal has served me well and is a great entry into aerial still photography for several reasons... - It mounts very easily...

I can confirm that Ina crash the upper, lower or both boards will crack. The arms are really solid, however. Sent from my iPhone using Tapatalk

Well I put my dilemma to rest... I've decided to rebuild my 650 with the integrated f550 board. I was pretty happy with the flight characteristics prior to my little crash. Thanks for all the feedback everyone!

So if I'm hearing you all right, you're suggesting a pdb? :) Anyone know what the f550 integrated board is rated at? Guessing at least 180 amps since they kit it with 30 a escs Sent from my iPhone using Tapatalk

Sold.

Hey all, Where does everyone stand on using a power harness instead of a power board? I'm leaning towards the wire harness for a new medium lift quad (3kg auw). I'm using 940kv motors and 30a escs on a 3s2p setup. Thanks.

I can say from personal experience that the board will be destroyed in a crash with the aluminum arms. Top plate cracked in three places and two on the bottom plate. Here's the crash: http://www.youtube.com/watch?v=A6nqcPBpz2o&sns=em Sent from my iPhone using Tapatalk

I normally wouldn't continue flight with these oscillations but I climbed up over that tree a bit faster than I would have liked. When it leveled out briefly I thought it may be good but then well, you see what happened. It wasn't a maiden. I previously had really solid flights with the same...

The smoke wasn't for effect. One of the lipos ignited. Scary stuff Sent from my iPhone using Tapatalk

Had a major crash yesterday on my hex. Lots of carnage and smoke! Now if I only knew what went wrong.... Thoughts? I haven't fired up my Naza again - if it comes to life, think I should still use it?

Just a little bump as the parts are still available...

Totally agree about the arm extensions. I added the extended aluminum arms from ReadyMade RC to my F550 as well upgraded the motors. It's essentially a 650 now. With 12" props, 2 3S 4000mah lipos in parallel and AUW of 3kg I get over 12 minute flight times. Included on my rig are a Gaui crane 3...

Thanks for the feedback guys and sorry for the delayed reply... I agree that a cradle type gimbal may be a better option even though the trend seems to be the single-sided versions. I also believe in buying things once (within reason). While I'd love to go for a high-end gimbal, I have to be...

Greetings, Rourke and welcome. The following thread may help you in determining if the F550 is going to be a good machine for you. Personally, I agree that it's a fantastic place to start. Good luck! Check out this thread...

Hey all, I'm looking to update the gimbal for my Sony NEX and considering purchasing the Asterix Brushless gimbal from BambuCopters.com - http://www.bambucopter.com/asterix-brushless-gimbal/ Has anyone dealt with them? I'm a bit leery as there is no contact info and I can't say I've seen their...