Recent content by gmango

BrushlessGimbals.com Hi I purchased the conversion kit. I was only able to communicate through e-mail when placing my order. In my e-mails I specifically indicated I was interested in the a 2-axis conversion kit. When I got my order, I was charged for the 3-axis and that is what I recieved...

I am having some twitching issues with the S800 in a hover. It behaves as if I am giving some very quick stick inputs to elevator and aerilon. I updated the firmware to current version and it appear to be ok for now. ESC are up to date. Has anyone experienced the twitching.

I am replacing the esc. Talked to the Paul at Century Helicopters. He thinks it could be the power connector inadquate he recommended EC5 connector over deans.

I tried on asphalt and grass. It actually lifts off and tilts at about a 3 degree angle.

Yes I tried to lift off, and it tilted toward the slow turning motor.

Has anyone else experienced this problem. I had all esc replaced, S800 completely inspected and updated. Suddenly one of the motors does not spin up to necessary speed for lift off. I inspected esc solder and did solder touch up. I even switched arm/motor it to different slot and still same issue.

Robert You obviously, do not remember clearly the E85 UAVFrame purchase I made because our lines of communication were not poor or slow (as you say), they were non existent. Let me see if I can put it in perspective for you, Imagine that you sent me $5000.00 worth of product and it was agreed...

Robert I can understand you needing to clean up your act, but don,t act stupid. Lets see if I can refresh your poor memory. I purchased one hexa, UAVFRAME, with a Futaba receiver. The UAV FRAME is cabon fiber monoque, very unique. Shipped to the San Jose California. I went to your site and it...

Bad guy Robert was non responsive with me. I sent him over $5000.00 for a multirotor and he never responded to any of my e-mails or phone calls. I will never spend a penny on his products. I am located on the west coast and every single person ( 3 people) that had a dealing withRobert was...

Thank you!

Can any one tell me what the frequency of the SAVOX SC-1258TG servo? The WooKong M alows for frequency input on the gimbal settings. (50 Hz to 400 Hz)

I have had same issue with Robert. I have no clue what he is up to. Beware!

Thanks!

My ESCs replacements came in today. The S800 flew fine and esc felt warm. I have a question. The current WooKong assistant manual say that when the firm ware is updated, that you must not power the battery. What does that mean? Can you even access the S800 through the software without plugin...

Holy Cow! You have got to photograph what went wrong with that motor. The people at Century Helicopter told me that the S800 could fly with 5 motors but if you lose 2 motors remaining motors must be in a Quad configuration. I hope I never test that theory, my arm with replaced esc come in this week.