The BMW of Multirotors!
CineStar-8 500mm Kit (NOT A CLONE BUT THE REAL DEAL)
All Mikrokopter German electronics:
Mikrokopter Flight Control V2.5 ME
Mikrokopter Navi-Ctrl V2.1 with External Compass
Double Quadro V3 - Cool: Latest Version of the MK ESC’s (REDUNDANT SPECIAL VERSION, Eight ESC, 4 on...
No problem: I've been ill on and off for 2 years, so I'm in some time warp anyway..lol
I ended up with an RCTimer Legacy and a Phobotic CP controller. These are my videos>
Thanks very much! I went through my files, about 50, with the other program and couldn't see anything. Hopefully I'll have better luck with this one. I know most of the files are just A2 setup stuff and motors were not on, so I can exclude them. Sure wish the files had a time, stamp. Feels...
Since I have a Graupner MX-20 for my Mikrokopters I just used PPM from a Graupner Rx. Added a Telemetry module for 2s-14s. I like Graupner for the Voltage telemetry and the flight info stored on the Transmitter (SD), not just the iOSD data, which seems a bit flaky.
Nice video!
Hey guys: I was looking at one of these too! I was thinking it might mount under my Cinestar, which has 25mm brackets. Just wondering if I can offset the yaw motor enough to balance it all, or I should just get the "drone" version (rubber balls and all) and mount it on a CF...
Yep, that is the way I have my Graupner MX-20 programmed for my Naza. GPS-ATTI-FailSafe on one 3way. I am also using one wire on channel 8 of the Rx, and SUMO12/PPM.
This might help too?
http://vimeo.com/82434688
If you are still having trouble let me know and I'll try an post my setup file...
The older GR-24L with version 3.75 works fine. My two new GR-24L's did not work with failsafe, and have ver 3.78 If you buy a GR-24L, or any Graupner Rx, it might come with a later firmware version, which is not compatible. It can be made "safe" if you change a setting on your Graupner Tx...