Recent content by girthquake

I already fried one tx that way running the power from the dji iosd's 22v out. This test was running power off a 3s battery at around 12v to the tx, and running the camera off the immersion's 5v out.

Like I said I've been trying a lot of different equipment with a lot of different combinations. The walking around with the fpv completely detached was with an immersion 600mw tx with a 3 fan rhcp antenna running from a 5v camera, and an immersion 5.8 duo diversity receiver with 7" helical...

Doing that test with no success is what finally led me to post here, I walked all around my ground station carrying my immersion tx and a 5v camera and only got static!

Hi, I'm amazed to see so many people here getting usable video signals on here! I personally have been struggling to get even static most of the time. I've been flying an s800 and 3dr x8 for a while and from the get go there have been video transmission problems. I don't know how much more...

Fleabane, I can't remember exactly where I read it that that was a necessary step in upgrading the firmware, and again I can't confirm that as the cause of the crash, but after putting the whole thing back together and recalibrating the compass it worked fine. It doesn't seem like the gps would...

I've got the gh2, interesting to hear that there is a difference like that between those to zenmuse models. I'm not sure I follow your suggestion that the Roll/Tilt section has rotated around the rear tube. I don't think it took enough impact to rotate anything but the brushless parts, and...

So much of maintaining these machines is a slow tedious process, I can take a little more at this point. I've been talking with my dealer to try and figure out what to do next, thanks ed!

I'm not 100 percent sure of the cause of the crash but my suspicion is that I didn't recalibrate the gps after upgrading the firmware.

Hi guys, I'm having some trouble getting my zenmuse to calibrate. I just got the whole s800 back up in the air after it flipped over on take off and broke a couple of arms. The z15g on it didn't sustain any visual impact or damage, and the first time I took it out shooting after repair it...

I'm investigating making these two components work together myself, were you successful?

Have any of you successfully set your RLG up to come down when you enter RTH mode?

Hi All, new to flying and to your forum, but scouring all of your posts here has really helped me a lot, so thank you all! I've installed the DJI retractable landing gear on an s800 with wkm but I'm having trouble setting it up to put the gear back down automatically when I enter RTH mode. If...