I have loaded my 550 (Hex) with Immersion 5.8 500Mah, Eagletree OSD and GPS... also have LED on it.
I'm getting very short good video range ... after about 50meters the video starts getting quite a bit of interference/noise.
I'm using stock antenna so far for both transmitter and receiver and...
Thanks Kloner... I knew something wasn't right... I'm happy now except that I just burn my e-logger by forgetting to add a resistor to the tempB to monitor my 2nd video/light battery. Made my whole harness and it was looking good except that I forgot to add the resistor. It was a matter of 2...
I just replaced my packs and got brand new batteries as my previous set weren't holding charge. I still feel that its consuming too much... I would love some feedback.. data below:
F550
Turnigy nano-tech 4000mah 4S 45~90C
Stock Motors and ESC
Graupner 10-5 Props
Weight: 1765g (Hex no Battery) +...
I got GPS.
I don't think is GPS blinking ... its a very open area and I still have the control from home when is blinking.
I will try to calibrate on low... I only calibrated on full. Very annoying because this happens every time.
Very weird. I got I GPS, yes... I charged up to 16.8 and went for another spin... at 15.3 started to stop the trottle up and blinking red non stop. My first warning level is only supposed to be triggered at 15.20 according to my settings and
only at 15 to reduce throttle. I need to get a...
Out of topic question...
I'm having a problem of my VU start blinking red within a couple min of flight... when I check battery voltage monitoring and its on 15.6 which is too soon according to my config.
Any tips?
I'm having a problem of my VU start blinking red within a couple min of flight... when I check battery voltage its on 15.6 which is too soon according to my config.
Any tips?
Got it flying... it is inverted... L is right and blank is Left. WTF
It was out of balance because after I changed the props I didn't balance it... working on it now.
I just put my old prop on top of the new graupner and I see that the L Graupner is the same of my right prop... So weird... I am comparing one by one to see if they made a mistake or something... I will post a pict.
Something wrong... the motors are spinning in the proper direction... just like they were working before.
First front right spins counter clock wise and to the left is clockwise, counter clock...
The counterclock I put the L prop and clockwise I put the other prop.
It won't fly... feels like...
Something wrong and I hope you guys can help.
I put the washers and the props in. Graupner 10-5L are installed on the counter rotating and the one without L on the clockwise rotating motors.
I try to fly and the thing doesnt get out the ground...
Is it the other way around? 10-5L would be the...