Recent content by Fit101

Tahoe, with a smaller quad like that, it only takes minor input to get it to move in any direction....slight movements (pitch and roll) get exaggerated to the flight controller. (Think of a tight rope walker with thier crazy long balance stick...makes movements happen slower and more time to...

What size is your quad and did you adjust the gains? Can you post a picture of how you have the FC mounted?

I have a 650-V8 I'd like to drop another SuperX into, it will require the PRO version to handle that configuration. Or I can get rid of the 8 motors and SC's, upgrade to 4 larger motors and SC's, and save some money by not needing the Pro version,but rather running the "Basic" SuperX model...

I've had similar results with the SuperX on my Tarot 960. Pretty much did no tuning out of the box...left the gains at the stock settings and made a minor adjustment to the radio sub-gain. Position hold and RTH is as you described. I pulled off a RTH from 1160ft up and watched it land within a...

Nice job!

Very cool Sleepy!

Ok...lets try this video link again... https://www.youtube.com/watch?v=pjvhs7h89sg&feature=youtube_gdata_player

Here's a 10 min FPV video of a early test flight checking out the stability and consistency of this platform. It's not a overly exciting video but keep in mind the camera was not attached to a gimble, but rather directly attached to the lower plate. The landing was done with the hands off RTH...

I have the SuperX in my Tarot 960 Hexa weighing in at over 10lbs with FPV gear. This FC is unbelievably stable... even in a brisk wind. The return to home and land function is the real standout. I did 2 RTH landings hands off that placed the Hexa within inches of the previous landing. I flew the...

I'm kind of thinking the same thing, I might have to sell it before its too late! Here's some vids of it flying last summer. https://www.youtube.com/watch?v=DCukZSq4JEw&feature=youtube_gdata_player https://www.youtube.com/watch?v=nsZ956GJ_Z8&feature=youtube_gdata_player...

It seems like all I read about is issues with XA electronics! I have a 650v8 I built last summer with v2 electronics and have had nothing but good luck with it. It flies rock solid... although the RTH function is sometimes inconsistent and can overshoot it's home position on its way back. I did...

Rods: .390 dia Rods center to center: 2.242 Landing gear measurement front to back is difficult due to how much flex is in the materials used. But figure approximately 6.10 Bottom of rods to ground is approximately 6.75 By the way, all measurements are in inches.

Hi Ricoklausi, Those are fiberglass props I got from Jeffrey at XAircraft USA. xaircraftusa.com They fit perfectly, but instead of a slot its a straight hole and a washer. Works good!

Hi everyone, I'm pretty sure this is one of my first couple posts here so I hope it's a helpful one! While doing plenty of reading Across the internet I've noticed many people are complaining of issues with the XA electronics. I wanted to share my experience with it considering I either got...

Are these still available?