Recent content by fajar

gopro 3 is likely to set them back a few months of production time. It is 25% lighter and the zenmuse is factory calibrated to the exact weight of the camera. If they want it to fit both hero 2 and 3 model, they may have to change the design.

now that gopro 3 is out, any updates about the zenmuse?

yep... I know a couple of guys who have done it. They're not in this forum but you can send me a pm if you're interested to hook up with them.

I'm in eastern suburbs.

use blue loctite to secure the nuts, they'll be alright.

Auto Pilot Module End of last year marks XA’s third generation of flight controller system. I remember sometime about one year ago a forum that I've been mostly active in was glowing with people sharing their experience and enjoying themselves flying XA lines of quad. There were fairly a lot...

hi Ian, I'm sydney, too. I got a couple of quads and one octo so if you feel like having a fun fly together, let me know.

+1 for cnchelicopter.com.

Xaircraft has a skype account and I always get a response whenever I send a message to them through skype.

Cost you even more than buying XA's hexa frame.

I dunno about the esc but the Naza does support flat hexa. There's a much cheaper flight controller system due to release by XA, though.

Did you load the correct firmwares for the v2 AHRS and FC? The current firmware and software release is not a proper release, its a limited release for those who just want to get their quads to fly without waiting for the proper release.

Definitely not linkage one as gear drive gives you better accuracy.

^^ there's no announcement being made by XA in China for such recall :(. However, there is an ongoing upgrade program for newer FC system with substantial rebate. Here's the info.

There's no recall being made by XA. If there is such a recall, there would be an announcement made in chinese RC forum, so far there is none. However, there is an ongoing upgrade program with substantial rebate that lasts until end of the year. Here's a the info.