Recent content by Craig9080

So after replacing all bearings and ESCs it is flying great minus a few excess vibrations. 90% sure it was actually and ESC issue as I had a tough time calibrating one for throttle input when I was doing my rebuild. Anyway, here is a great vid of it flying recently. Thanks again for...

I just realized that I had my maiden video set to private. Please take a look a notice the "cogging" sound from the get-go. Anything to be concerned about?

This will give me some more motivation to shorten my motor wires to lesson that amp draw. I also have a eLogger v4 that I will be using now to log amp draw even on bench testing.

Thank you, this is some great advice. I have already ordered new sets of bearings for all of my motors, I'm very sure that at least one of them is bad as I can now hear a tick when I spin it manually. This makes me concerned that one of my motors was bad from the start as that odd "cogging"...

Hi Everyone, Well after taking about a week to pull my head out of my 4th point of contact, I was able to get my naza configures correctly and I was in the air for my maiden. It was super stable but had a few times where I got very small oscillation and just chalked it up to gain. Well on a...

Great News!! I'm and Idiot and had the VU plugged into the GPS port. After talking with others, and DJI, it is apparently semi-common for people to do this...which makes me feel a little better. So lesson for everyone else out there, if your VU is acting up and your computer cant recognize the...

I mounted it in the frame. I had everything else already in the frame when I did my bench test. The next morning I just bolted the naza to the frame and then ran my antenna wires and put the top plate on my QAV500 - then all this trouble happened when I though I was literally 5 min away from...

Yes, the driver was installed...and reinstalled on all 3 computers. I have ordered another VU in the hopes that it is just that.

No worries, I appreciate that you are trying to help. I posted the same thread over at RCG and so far it hasn't received any posts.

I understand that it will go green when connected to the computer, I was able to get everything to work fine last night. The problem is that when its not connected to the computer is does not do the normal startup sequence and instead goes to red and green slow flashing that eventually just...

I have gone one step further, I tried a total of 3 different computers now. The manual says that a solid green is "connect to PC correctly." I'm starting to think that the VU is just going out on me since the naza itself seems to behave like it should regardless of the lights. It is worth...

Trying, no luck. The part the urks me is that even without the computer it just flashes between red and green slowly and eventually stays on green regardless of any input I give it.

Hello Everyone, I asked this over at RCG but i figured I would try my luck asking it here as well. I had everything bench-tested yesterday with the NAZA out of the frame and everything seemed to be working fine. This morning I went to reverse my rudder channel on the software and it would not...

I am having a very similar issue along with the VU not being able to connect to the computer. Has anything helped? Also, how DO you execute a factory reset?