Gday,
Wondering if anyone has a link where I can buy a wireless intercom headset that myself and my camera operator can use to communicate as I am finding myself walking around a lot while flying and unable to talk to the camera operator. Looking for a single headset with mic.
Thanks
Tim...
Does anyone know if you can run 6s into the retracts on the rct s800 or do you use a separate batt with lower voltage. They have a output for a gimbal on the board but that comes out as 6s as well which would blow my gimbal up!!
Thanks Tim
I was changing the camera setting the other day when i picked up the mk and rocked it back and forth and all of a sudden everything went dead. The bind light was flashing madly and very faint (not like the flashing when you loose signal) I hadn't even been in the air so batt was full but when it...
Its not the programming of the esc's? Auto cut off like programming for 5 cell and putting 4 cell in it? But i can't see how they would all shut off at the same time????
Thanks Guys
i have taken the plunge and purchased some of these https://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=14698
and these
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=19511
as there are no nano techs in the Australian website. Ill see how...
Hi,
I have been using turnigy nano tech batteries for a while now. Just wondering what you guys think of the standard turnigy blue battery's against the nano tech? Are nano tech a way better option?
Cheers
Tim.
Have you done a perfect acc calibration?
My "manual control speed" is set at 5.
Take the servo horn off after you have calibrated gyros and mechanically level it. I see you don't use a poti to control the tilt?
Hi Dave. Are you saying erratic behavior getting the information into your pc or the sd card was causing the mk to act erratically in the air? Hopefully not the latter, if so mine is going in the bin!!!