Yep, I put 2 jumpers in signals 1-4. Got a solid green now when I power both Rx and Tx, and a solid red when I turn Tx off, so i assume they're bound.
Both sticks to bottom left, but motors aren't turning on at all. I've plugged in all 3 signal wires..
Hi guys,
So just double checking mode 4 is correct for binding and using Sbus.
Jump signal ch 1 to 4
Set Ch output: 9-16 in Taranis
D16.
Thanks!
Edit:
Guys, just tried to bind it in Mode 4. It is green when i binded and kept signal jumper in.
So i re-binded and removed the signal jumper...
Yep got it resolved! Sent it back to Aloft and got a replacement, it binds perfectly to D16, Ch 1-16 now!
Quick question. Which mode should I be in for the binding? If you look at X8R manual, there's 5 modes...
I have Sbus... No plans for gimbal right now but do have plans for telemetry.
It's able to bind in D8 though... Maybe i should do what the Frsky tech said and remove the shell and try to bind in D16 mode, and if it works in D16, that means the F/S button is defective?
I dont know if I would void warranty policy from Aloft if i remove the shell though... I'll contact...
That was the video i watched before binding for my first time. No jumper on any signal pins, D16, channel output 1-8, external RF off.
All i got was a flashing red LED.
Thanks so much for all the help so far, really appreciate it!
I just got a reply from Ray (Frsky tech).
Basically, my X8R can bind in D8 mode but not D16 mode, so he wanted me to take off the shell and try to bind in D16 mode. And if it can bind in D16, that means the F/S button is...
I'll take a look tomorrow but I just got this reply from the Frsky tech after explaining to him that I got it to bind using D8, Ch 1-8, and jumping channels 7 and 8 on receiver:
Kind of confused..
So i just tried what Ray told me and I get a solid green now. I turn off my Taranis and it flashes red. So it binded.
But which method is correct, the one you guys suggested or Ray's? He put me in Mode 1 while you guys suggested Mode 5 of the Rx binding Operation in the manual.
Anyways, now i...
Hi guys, so i followed the instructions and placed 2 jumper pins on channel 1, 2, 3, 4.
Change channel output to 1-16 on the Taranis. Mode still D16.
Nothing changed. Still cant bind... Still getting the flashing red LED... What could possibly be wrong? I dont understand why it's so hard to...
Thank you.
Do you know a good place that kind of walks you through everything about Taranis X9D from getting started to the more advanced stuff? I know there's a video series on YouTube (By eastbay rc + aloft hobbies), which I'll watch. Just seeing if there's more.
Btw, so if I want Sbus for...