That's not a severe injury. It sucks but likelihood of bleeding out is very low.
Believe me. I know what I'm talking about. Severe injury is one that is life threatening. That is not.
Compound fractures with bones sticking out of limbs= significant injury. Broken ribs with the potential...
Severely injured from a Phantom- from a height of 10 feet. Yeah right. Though after the bride and groom hear a UAS, I doubt that they'd have one as part of their ceremony.
Here are the slides that were used.
http://www.kramerlevin.com/files/upload/UAS_WebinarSlides.pdf?hc_location=ufi
He'll be posting the audio after it processes. As a quick note- he didn't answer the question about the potential Booker legislation.
Yeah- happened to me the other day, I was in GPS mode - hovering 8 (2.5m) feet off of the ground and the unit just dropped even when throttle was applied. No possibility of VRS since I was stationary. Fortunately, I had a B rig with me. Had to send the unit back to DJI since the frame cracked...
Interesting thing is that this would be allowed under the microUAS proposed rule.
Anyone can fly- but the key difference is to be able to fly well. There's a big difference between someone who knows how to get the right shot and someone who sucks. And that's on any platform be it a DJI...
Update #1- both CP's updated smoothly. Both auto-tuned well. The gimbal analysis graph is awesome.
Weather is awful so can't fly today but looking forward to taking both units in the air.
I have a Xaircraft SuperX with OSD linked to a front facing camera- which is then connected to an ImmersionRC 5.8 tx. I have a second ImmersionRC tx hooked up to the camera on the gimbal. They both operate on separate channels. I have two monitors. One of the monitors is a Flysight so I can...
The Adir board is awesome. Clean power, enough 5V and 12V outputs and having that switch is great. I can have all my electronics powered on the gimbal (rx, hdmi convertor and immersionrc tx) so that the only wire that goes up through the yaw motor is a power cable.
Hey CameraJ- make sure to check the physical channel in the Phobotic software. (e.g. when you select the individual channel you want to assign make sure that the physical channel is 8) also make sure that the futaba rx is set to the right mode too. (if you're using SBUS and the physical...