Diode situation is fixed, I got it off of ebay, it wasn't bang good. Confirmed that it was a v.1 from the seller. Now its a esc/calibration firmware issue. Someone suggested that I upgrade the esc firmware and set the calibration on blheli suite
Update: put in the diode, no stuttering when connected. Did the calibration procedure, through clean flight I believe the esc are calibrated but now the motors are behaving erratically. When I move the sliders all up, the motors all respond differently, someone go to the appropriate power...
Looks like the REV 6 board has a usb problem where the voltage is flowing backwards, I'm looking for a diode to put in at teh momment, will report back, this is not a 6a or 6b board
3d plastic printed hovership frame
naze32 rev6
old crystal radio, works fine but the ranges don't go far enough, hence calibration via cleanflight
emax 1806 package with 12a blheli esc
matek power distribution board
I can't get the range of the transmitter to go past 1550, I'm just using the...