Search results

Diode situation is fixed, I got it off of ebay, it wasn't bang good. Confirmed that it was a v.1 from the seller. Now its a esc/calibration firmware issue. Someone suggested that I upgrade the esc firmware and set the calibration on blheli suite

Update: put in the diode, no stuttering when connected. Did the calibration procedure, through clean flight I believe the esc are calibrated but now the motors are behaving erratically. When I move the sliders all up, the motors all respond differently, someone go to the appropriate power...

I need to do that also, I'm going to pull the power lead off three of them, leaving the ground and power

Looks like the REV 6 board has a usb problem where the voltage is flowing backwards, I'm looking for a diode to put in at teh momment, will report back, this is not a 6a or 6b board

3d plastic printed hovership frame naze32 rev6 old crystal radio, works fine but the ranges don't go far enough, hence calibration via cleanflight emax 1806 package with 12a blheli esc matek power distribution board I can't get the range of the transmitter to go past 1550, I'm just using the...