Recent content by AGImaging

Regarding you X1 tilt issue. Check out this YouTube link. I had a similar problem and it was very helpful: http://youtu.be/mKpCJhkLZ1Q

Regarding your X1 tilt issue, check out this YouTube link. It might be what you're looking for. I had the same problem: http://youtu.be/mKpCJhkLZ1Q

I had the same problem recently. Had to replace the central circuit board on Phantom 2 (non-vision). But everything is out of whack. Nothing is working. Please see my thread for details. http://www.multirotorforums.com/showthread.php?20504-Central-circuit-board-replacement-DJI-Phanton-2 Can you...

Hello all. I had to replace the central circuit board due to a blown capacitor. Stupid mistake on my part when upgrading the video transmitter to ImmersionRC 5.8GHz, 600Mw. Connections fit perfectly from the previous one (Boscam TS 352) but I did not notice that the wires were set up...

That's the central circuit board.

Checked this out in more detail last night. Figured out what happened. Blew a tiny, almost microscopic ceramic capacitor (2mm x 1mm, if that). I don't think there is a way to fix this other than replacing the entire circuit board. See attached photo. The ceramic capacitor is located right next...

Hello everyone. I posted this question in another forum but hoping I might get a quicker response here. I need help understanding what happened with my new ImmersionRC 5.8GHz, 600mw transmitter. I think I might have burned it out due to a stupid mistake. I have a DJI Phantom 2 where I...

I figured that might be the problem. Unfortunately, DJI does not have a Mac compatible iOSD assistant for download, only PC. It's not on their website from what I have seen.

Hello Everyone! I'm new to the forum and actually a new owner of a DJI Phantom 2 with the H3-3d gimbal, GoPro Hero3+ black edition, Boscam RX-LCD5802 Receiver monitor, and the 5.8Ghz TS-352 transmitter. I'm new at this and it took me most of the day yesterday to get everything setup. Test flight...