Built my first quadcopter and it doesn't work. I have a quadrino zoom powered by my battery and the J1 jumper soldered. My receiver works because I can run the MultiWii config and change values as I move the joy sticks. When I power it up the FCB led is lit and some of the props want to twitch. Any ideas were to start my analysis?
first time builder
- Thread starter joep
- Start date
Motopreserve
Drone Enthusiast
Did you calibrate the ESC throttle response? Did the motors spin without props? I'm not familiar with that FC, but it probably has a stick move to arm the motors? Also, did you do the calibration in the Multiwii config to get your levels at 1095-1500-1905?
just thinking of things that I ran into - I'm very new to all this too, and using a multiwii board.
Welcome to the forum. Good luck!
just thinking of things that I ran into - I'm very new to all this too, and using a multiwii board.
Welcome to the forum. Good luck!
Last edited by a moderator: