Hoverfly 4.6 Gimbal Problem On Power Up

[Earl E Adobtr]

HF, When things settle down could you fix the gimbal issue in 4.6 where it tilts full back after power up but before arming? Once it's armed it straightens out but never at the exact same tilt angle. This puts unneeded strain on the servos and it was not present in previous firmware.

 

[kloner]

not knowing the exact issue, but is your bind settings doing that or the board itself? you know how when a receiver isn't bound it goes to failsafe then where the radio tells it as it links up.....

 

[Earl E Adobtr]

Thanks kloner. Very possible that is the problem, where the board is responding faster than the receiver can bind. It may be that 4.6 allows the board to boot a millisecond faster than before. And it's not exhibiting this morning when everything is colder. Electrons travel faster in cold? At any rate, it's not HF's problem so no need for you guys to respond.