Recent content by djneils98

there are some motors the DJI escs aren't compatible with e.g. some Lok motors

i just don't get how they are doing this. phantom 1 with 2200mah battery goes for <10mins yet phantom vision with same motors, presmably heavier, and with (heavier) twice capacity battery flies for 2.5x the time of phantom 1

its only 3 grams lighter - will work fine

Maybe a bit big for fpv? ;)

http://multirotoruk.co.uk/sklep/drone-frames/dji-naza-m-v2-gps-h3-2d-brushless-gimbal-detail Mistake??

One of these possibly. Not cheap though http://www.tru-vumonitors.com/images/SRM-8.4_Series_Sunlight_Readable_LCD_Monitor.pdf 1000 nits (!)

amazing tech http://www.youtube.com/watch?v=VRKu785g0O0&feature=youtu.be

think it's actually the motors that make the sound

when I ascend or descend my quad I'm getting a little slow yaw-oscillation you can see the effect in this video http://www.youtube.com/watch?v=K4B7e0tenVA&feature=youtu.be is this most likely down to the yaw value gain? if so is it most likely to low or too high?

but it could be useful as had been said to change shooting modes etc and check pitch position. think i'm gonna test it

Up until now i've always flown my gopro with the WIFI off but it would be great to be able to monitor the gopro to set up shots on my phone while my quad is flying. Is anyone doing this? Just a bit concerned my 2.4ghz tx/rx or the naza gps might get interfered with and cause something bad to...

sooner or later an innocent bystander is going to get killed by a multirotor because of idiots like this and then what?

kloner - import the clip you wanna fix and then press the advanced settings button just to the left of middle at the bottom

thanks Hexa - those 2814s look like a good choice

It's nothing fancy-just a checkbox in the edit controls (where you can change thr frame rate etc)