Recent content by a468bu

I took it back out. This time I noticed it going in a circular pattern on GPS hold. In about a 4ft circle. I tested RTH with the fails age switch and shutting off transmitter. All worked as expected. I am running 3300mah 3c batteries. It started flashing red and I landed about 6 minutes into...

Ok I setup some different gains tonight and took it out for a flight. It is rock solid. I also read somewhere to take off in manual mode the switch. That's what I did. Works awesome. I see myself already wanting to build a disco and get some fpv gear.

I took mine out side today for the first time. Not sure what my gains are right now. Have to go back and check. It was a little wobbly though. Higher gains fix that? I was in atti mode. I switched to GPS and it was not holding position too good. I think I have to recal the compass.

Thank both of you for all your help.

I set it up in traditional mode, and did a test hover in my apartment tonight. All seems well. Thanks for the videos. I got a switch assigned to go into failsafe in any mode. This is a stock F450, Dji esc's, Dji motors, with Dji 10inch props for now. What should the gains be set at to start? I...

Nope :upset:

I have nothing else to test. I called the place I purchased it from. He said he is going to talk with dji about it and see if they know what's up. If not hopefully they will swap out the receiver.

Yes its set to d-bus and its plugged in the X2 spot

Just switched cable and reset it all back up. Same thing. Think the receiver is bad?

Already did that, Same thing. I just connected the receiver the traditional way. and that seems to have fixed it.

Heres what its doing https://www.youtube.com/watch?v=Wq3_mjB5rgg&list=UUshQPLQB8dv75Ymyhs8cgzA&index=1

Still can't figure this out. There is no mixing going on. I reassigned the 2 3-postions switchs and it still does it.

Yes aircraft mode. I just got home and going to start looking into it.

Well the problem is, its not boucing into the failsafe mode next to the mode its in. Its jumping to the failsafe mode between the other 2 modes.

Thanks. I watched your videos and I did have it setup like you explained. The gear switch would put the assistant into Gps-Atti-Manual modes. But the sliders were not rock steady and it would jump to the other side to failsafe. I will take another look today when I get home and if I can't...