I have not Zenmuse yet but I wonder how I should connect it to S800 when I receive it.
- S800 has a dedicated power cable (XT60 connector) which should be connected to the gimbal. Hence the gimbal and s800 will use the same battery pack. Am I correct? If it is correct, I wonder how much the flight time will be reduced using the same Lipo for Zenmuse and S800.
- Zenmuse manual states “use CAN-Bus to power and communicate with the autopilot” so I have to connect both the power cable mentioned above and the power from CAN-Bus? I have a problem. The PMU has two CAN-Bus ports. I have connected data link to one of these ports and the GPS to the other. There is also a CAN-Bus port on the GPS cable which I have used to connect the LED wire to it. So there is no more CAN-Bus port left to use for Zenmuse.