danielburns
New Member
Hi all,
I have a GH3 Zenmuse that just came back from a repair and noticed the firmware had been rolled back to a version before the 'working mode' control was added.
I've just updated the firmware on the GCU to the latest 2.4 version and the IMU to version 1.8...now there is no response to RC commands from my Spektrum DX8.
Does anyone know a reason for this? Is there a way to revert the firmware back to an earlier version and if so would this fix the issue?
Please help!
Dan
I have a GH3 Zenmuse that just came back from a repair and noticed the firmware had been rolled back to a version before the 'working mode' control was added.
I've just updated the firmware on the GCU to the latest 2.4 version and the IMU to version 1.8...now there is no response to RC commands from my Spektrum DX8.
Does anyone know a reason for this? Is there a way to revert the firmware back to an earlier version and if so would this fix the issue?
Please help!
Dan