Tarot 250 FPV Build Thread

Hoki

Hoki

Member
I'm going to be ready to build my next fpv copter soon. Almost all of the parts have arrived. Just waiting on the flight controller. I wanna do every step on here. I'd like you to all give suggestions and stuff.

Here's the things I ordered for it:

Emax mini Skyline32
http://www.banggood.com/EMAX-mini-S...-Support-Cleanflight-Baseflight-p-981151.html
Tarot ESCs(these are so thin and small and can easily slip inbetween my frame plates)
http://www.aliexpress.com/item/Taro...r-for-FPV-Multicopter-QAV250/32589741465.html
Propellers
http://www.aliexpress.com/item/16Pc...Props-CW-CCW-for-QAV250-C250/32411348423.html
Motors:
http://www.aliexpress.com/item/LE-T...t-270-Multicopter-Quadcopter/32520130066.html
Frame:
http://www.aliexpress.com/item/Taro...r-TL250A-for-FPV-Photography/32254934158.html
2mm connectors
http://www.aliexpress.com/item/20pa...r-plug-Lipo-RC-battery-Plugs/32326424879.html
Receiver:
http://www.aliexpress.com/item/Orig...link-AT9-AT10-RC-Transmitter/32551544427.html

I already have an extra eachine 600me CCD camera but I really wanted to put the runcam owl on it but I donno how to do that. I was wondering if I could plug in the runcam owl into the eachine transmitter cause the plug looks the same I think. I should be getting the rest any day now so I'll post pics of every step and stuff.
 


V

vadmcse

Member
Hi Hoki,

I didn't find info about "eachine 600me CCD camera", is this correct?
You don't mention the Eachine transmitter model.
About the OWL, i found this:
http://shop.runcam.com/runcam-owl/

Anyway, normally, you have a power cable and a video cable.
Looking at the user manual of both (camera and transmitter), you should check this:

Power supply voltage (5v, 12v...)
Power supply polarity
Video polarity.

If everything match, then you can connect it.
If polarity doesn't match, you can unmount the connector and mount in the correct order.
If voltage doesn't match, you should power from another connector.


hope that helps.


Víctor
 


V

vadmcse

Member
Ok, i see.
Now, is the Owl, the one i sent you in the link in my previous post?
If so, i don't see the SAME CONNECTORS
 

Hoki

Hoki

Member
OK I woke up in the middle of the night and walked downstairs like a zombie and did this in the kitchen. I soldered the ESCs to the frame and just bunched up the wires, zip tied them and stuffed them inbetween the top and bottom plates. I plan to not use the built in signal circuits for the ESCs. I'm just gonna plug them in and keep all that wire in the center where the flight controller will be. I'm hoping it will fit in there. I had these motors for it but I found out there are a bit to big and the holes don't match my holes so I need to get 1806 motors so I gotta wait a couple weeks now for that.
[url=http://postimg.org/image/fphyxlmh7/] [/URL]
[url=http://postimg.org/image/n0e694z8r/] [/URL]
[url=http://postimg.org/image/blzu7uthv/] [/URL]
 

You must log in or register to reply here.
Top