MadMonkey
Bane of G10
Price lowered
This is an almost brand new Skyjib. Our priorities are shifting so we're moving to different equipment.
The aircraft was built by Intelligent UAS and has been flown probably 10-15 times, just test flights.
Specs:
Frame: Droidworks Skyjib X4 Ti-QR
Motors: KDE 5215XF 435KV
ESCs: KDE 75A+ HV
Controller: DJI A2
DJI iOSD Mark II
DJI AVL58 VTX
It uses two 6S 16000mah batteries. One set of Gens-Tattus will be included with several more sets of both Tattu and Maxamps available.
Props seen in the video are APCs but a set of 18" T-Props are included.
Also included is a long Pelican case cut specifically for this aircraft ($1,500+ case, it's nice).
No radio is included. Futaba binds directly to the A2, we use 14SGs and they work very nicely.
This setup has 120-140lbs of thrust at full throttle. It has no problem at all lifting a built Movi M10 or heavier gimbals.
Here's a quick video from when I was getting it ready to sell (pretty much repeating the ad):
Asking $5,900 OBO.
This is an almost brand new Skyjib. Our priorities are shifting so we're moving to different equipment.
The aircraft was built by Intelligent UAS and has been flown probably 10-15 times, just test flights.
Specs:
Frame: Droidworks Skyjib X4 Ti-QR
Motors: KDE 5215XF 435KV
ESCs: KDE 75A+ HV
Controller: DJI A2
DJI iOSD Mark II
DJI AVL58 VTX
It uses two 6S 16000mah batteries. One set of Gens-Tattus will be included with several more sets of both Tattu and Maxamps available.
Props seen in the video are APCs but a set of 18" T-Props are included.
Also included is a long Pelican case cut specifically for this aircraft ($1,500+ case, it's nice).
No radio is included. Futaba binds directly to the A2, we use 14SGs and they work very nicely.
This setup has 120-140lbs of thrust at full throttle. It has no problem at all lifting a built Movi M10 or heavier gimbals.
Here's a quick video from when I was getting it ready to sell (pretty much repeating the ad):
Asking $5,900 OBO.
Attachments
Last edited: