Programming 9xr/Frysky DF

[erayymz]

Hello Everyone,

I have recently upgraded my remote controller after scoring a nice deal from hobbyking. Got myself following kit:

Note: I am using this for a hexacopter with NazaM V2.

• Turnigy 9XR Pro
• FrSky DF 2.4Ghz Combo Pack for JR w Module & RX (this)

I am trying to configure this thing, and I am stuck. I have a feeling that I may need more than 8 channels. This is why I am seeking your expertise.

Here is how the channels currently mapped:

CH1    AIL (Right Stick)
CH2    ELE (Right Stick)
CH3    THR (Left Stick)
CH4    RUD (Left Stick)
CH5    NAZA IOC (GEA SW: IOC On/Off, AIL SW: Home Lock, Course Lock)
CH6    NAZA FLIGHT MODE (RUD SW: Failsafe, ID0/1/2: GPS, ATTI, MAN)
CH7   
CH8

*Please refer to this diagram for the name of the switches.

Now as you can see, I have two remaining channels left. However, I still have following devices in the aircraft that I need to control with following respective switches.

• 3 Axis Gimbal: P1 Switch to control pitch & P3 switch to control yaw. RX connects directly to gimbal.
• Video Switcher: ELE Switch to switch between GoPro, and FPV camera. RX connects directly to switcher.
• Light Switcher: P2 Switch to control lights. 0% position OFF, 50% position "strobes on", 100% position "strobes and leds on" RX connects directly to switcher.

As a reference, this is how I want the controls to map:

ELE SW    CAMERA SWITCH PFV - GOPRO
P1    GIMBAL PITCH
P3    GIMBAL YAW
P2    LIGHT CONTROL OFF - STROBE - LED+STROBE
ID0/1/2    GPS - ATTI - MANUAL
AIL SW    HOME LOCK - COURSE LOCK
RUD SW    FAILSAFE OFF - ON
THR SW    UNUSED
GEA SW    IOC OFF - ON
TRN SW    UNUSED

Now, the question is, with remaining two channels left, how will I map these remaining 4 functions to the remote?