One more newbie question,
I'm trying to figure out the most professional way to power gimbal servos. What kind of setup and wiring harness have you made? I've planned to solder a some kind of Y-cable by couple of servo extensions and take + and - from 6V 5A bec and then take only signal from wookong m gimbal ports and lead them to servo extensions and again to tilt and roll servos. Is this right way to do it or do you prefer something else?
Thanks for your help,
Kari
I'm trying to figure out the most professional way to power gimbal servos. What kind of setup and wiring harness have you made? I've planned to solder a some kind of Y-cable by couple of servo extensions and take + and - from 6V 5A bec and then take only signal from wookong m gimbal ports and lead them to servo extensions and again to tilt and roll servos. Is this right way to do it or do you prefer something else?
Thanks for your help,
Kari