Mojave
Member
I am going to be getting a set of 10,000mAh 6S 25C batteries. I typically install XT60 ends on my lower amperage 4S batteries and have a parallel charge board. I always make sure that all the batteries are within 0.1 volts of each other, and have not had any problems. I want to be able to parallel charge up to 4 of these 10,000mAh batteries but XT90 charge boards are not common.
http://www.progressiverc.com/parallel-charge-board-for-jst-xh-xt60.html
Question: Would I be taking a big risk by producing a set of adapters that will go from the XT60 to allow plugging my XT90 battery for charging at 10 to 12 amps?
http://www.progressiverc.com/parallel-charge-board-for-jst-xh-xt60.html
Question: Would I be taking a big risk by producing a set of adapters that will go from the XT60 to allow plugging my XT90 battery for charging at 10 to 12 amps?
