I know I may be re writing or asking something from a previously post that has been tapped about. Some where in the last day I have come across on the net a post where WK-M is not really set up well for OCTO's but it works best for Quads. So in the post the person Y connected out M1 through M4 and attached two motors to each port, at that point you section off the Octo as two motors next to each = 1 quarter of the copter.
Or one quad of the copter. Then for each set of motor he had them turn the same direction, ect.... motor 1&2 would turn ccw, where 3&4 CW, 5&6 CCW, and 7&8 CW.
I am curious what people think about that set up, and for anyone that has tried or set theirs up that way that what was the results like.
Cheers
Or one quad of the copter. Then for each set of motor he had them turn the same direction, ect.... motor 1&2 would turn ccw, where 3&4 CW, 5&6 CCW, and 7&8 CW.
I am curious what people think about that set up, and for anyone that has tried or set theirs up that way that what was the results like.
Cheers