No yaw control on new Naza M install

[bhockenstein]

I have been running my 450 sized quad for several months now with a Naze32 board and just installed a Naza M (V1) onto it. Everything seems to be running fine except I do not have any control over the Yaw of the quad. Nothing I do on the sticks seems to make a difference and after about 20 seconds it begins to spin and I lose control.

- Rx/Tx signals are acting normally on the Naza software
- ESCs have been individually calibrated
- Advanced IMU calibration was done
- No GPS/Compass module installed

Anyone have any thoughts on what may be the issue?

 

[AndyPG]

Hi B,
So, the rudder slider in assistant is working properly when you move the rudder stick on your tx?
Have you got the Naza FC mounted correctly?
Are the gain settings per recommended?

Andy.