Naza m v2 questions

Pgirnus

Member
Hey, I have a issue with my new build it is a x quad with naza m v2 I have a spectrum dx7 and a ar6200 receiver.
On my test flights it is flying great no problems then three minutes in, it lands all by itself no matter if I give it full throttle.it is not in failsafe mode or voltage protection mode. I am afraid to fly it more than 50 feet away because it might just start to land when I am I a bad area. Has anyone seen this before?
 

Pgirnus

Member
Hey, I have a issue with my new build it is a x quad with naza m v2 I have a spectrum dx7 and a ar6200 receiver.
On my test flights it is flying great no problems then three minutes in, it lands all by itself no matter if I give it full throttle.it is not in failsafe mode or voltage protection mode. I am afraid to fly it more than 50 feet away because it might just start to land when I am I a bad area. Has anyone seen this before?

Atg-16-680mm
naza m v2 w/gps
2-3s 2200 lipo in parallel
9-5 carbon fiber props
hobbyking f30 esc with simonk firmware

Please I'm stuck here guys! Any suggestions?
 
Last edited by a moderator:

Pgirnus

Member
I was able to fix the issue it was the receiver advanced protection. I just had a 15 minute flight and everything was perfect.
 


Top